MCU Clock & PLL Simulator Studio | MCU Clock, PLL Synthesizer, Loop Filter - Features & Free Guide | Shamoji DRIVE

All-in-One MCU Oscillator & Instruction Cycles (Fcy/Tcy), Delay Loops, Timer Prescalers, UART Baud Errors & PLL Synthesizer Simulation

From PIC, AVR, ARM Cortex-M, and ESP32 clock timing and instruction cycles to delay loops, hardware timer prescaler auto-search, UART baud rate error matrices, and complete PLL synthesizer design (multiplier/divider search, 2nd-order loop filter, and transient lock-up waveforms)—all running 100% locally in your browser.

Recommended Use Cases

Key Features

How to Use

  1. Select Architecture & Oscillator Frequency (Fosc): Choose from PIC, AVR, ARM Cortex-M, ESP32, or 8051, and input the crystal/oscillator frequency in MHz or kHz.
  2. Choose Analysis Tab: Navigate between Cycle Times, Delay Loops, Timer Interrupts, UART Baud Errors, or PLL Synthesizer.
  3. Enter Target Parameters & Copy Code: Specify target periods, baud rates, or PLL frequencies, and copy recommended register values or C snippets.

Frequently Asked Questions (FAQ)

Q. Why do classic PIC microcontrollers execute 1 instruction every 4 oscillator clocks?
A. Classic 8-bit PIC MCUs (PIC10/12/16/18) use an internal 4-phase clock architecture (Q1 to Q4) to pipeline instruction fetch, decode, execute, and write-back cycles. Therefore, instruction frequency is Fcy = Fosc / 4. Modern RISC MCUs like AVR, ARM Cortex-M, and ESP32 feature pipelined single-cycle execution where most instructions execute in 1 clock cycle (CPI = 1).
Q. What is the maximum acceptable baud rate error for reliable UART communication?
A. As a general engineering rule, the cumulative baud rate error between transmitter and receiver must remain within ±2% to ±3%. Exceeding this margin causes the sampling point to drift away from the center of the bit toward the transitions, resulting in framing errors and data corruption. When using high baud rates, choose crystals with integer baud multiples such as 11.0592 MHz or 14.7456 MHz.
Q. Why are PFD input limits and VCO frequency ranges critical in PLL design?
A. The Phase Frequency Detector (PFD) and Voltage-Controlled Oscillator (VCO) inside a hardware PLL have strict physical operating boundaries specified in the silicon datasheet (e.g., 1 MHz to 2 MHz PFD input and 100 MHz to 432 MHz VCO for STM32F4). Selecting multipliers or dividers outside these boundaries will cause the PLL to lose lock or generate excessive phase jitter.
Q. How do loop filter values (R1, C1, C2) and damping factor (ζ) affect PLL performance?
A. The loop filter converts charge pump current pulses into a smooth DC control voltage for the VCO. The damping factor ζ (zeta) determines the stability and transient behavior of the loop. A value of ζ ≈ 0.707 (near critical damping) provides the optimal compromise between fast lock-up time and minimal frequency overshoot. Underdamped loops (ζ < 0.5) oscillate excessively, while overdamped loops (ζ > 1.5) take too long to settle.

Keywords: MCU Clock Calculator / PIC Instruction Cycle Calculator / Timer Prescaler Calculator / UART Baud Rate Error Calculator / PLL Synthesizer Calculator / STM32 Clock Configuration / RP2040 PLL Calculator / Microcontroller Delay Loop Solver / Loop Filter Calculator / MCU Clock Studio

Open Tool Workspace | Tool Guide & FAQ